|
| High speed 2 axes robot using high
cost performance X and Z axes in combination |
| ■ |
High speed type with 0.57sec cycle
time as standard. |
| ■ |
The operation area size is 330mm for X axis and
100mm for Z axis. |
| ■ |
3k payload at the end section is
assured. |
| ■ |
As the wiring and piping for installation of the end
spindle are enclosed in the main unit and pipe shaft,
there is no harness projecting upward, making
installation in a smaller space possible. |
|
 |
 |
|
 |
|
|
X axis
|
Z axis |
| Motor output |
200W |
200W |
| Repeatability
Note 1 |
+/- 0.02mm
|
+/- 0.05mm |
| Drive system |
Ball screw(C7
class)
|
Timing belt |
| Deceleration
ratio |
Lead 20mm
|
Equivalent to
lead 25mm |
| Maximum speed
Note 2 |
1500mm/sec
|
1500mm/sec |
Moving range
|
330mm
|
100mm |
| Cycle time |
0.57sec Note3,
0.78sec Note4 |
| Maximum
payload |
3kg |
| Robot cable
length |
Standard: 3.5m
OP: 5m, 10m |
| Controller /
Power consumption |
DRCX0505 /
500VA, RCX142 / 600VA |
| Weight |
21kg |
|
|
Note 1: |
Positioning repeatability precision in a single
swing when residual vibration is stabilized
(variable depending on the load and stroke)
|
|
Note 2: |
When the moving stroke is short, the maximum
speed may not be reached. |
|
Note 3: |
Reciprocating time in vertical direction (50mm)
and longitudinal direction (150mm) with the arch
amount of 50 (when executing rough positioning
arch motion with 1kg load) |
|
Note 4: |
Reciprocating time in vertical direction (25mm)
and longitudinal direction (300mm) with the arch
amount of 25 (when executing rough positioning
arch motion with 1kg load) |
|
|
|
|
|
